/////////////////////////////////////////////// SDA 100 - MUSTANG Firmware Release Notes Copyright 2020, SteppIR Communication Systems. Authors: Jim T. K7IRF, Scott T. /////////////////////////////////////////////// v56 [10-31-17] -Changed how Global and Band offsets are applied. Note: The way the global offset menu works prevented the offset from being automatic so it will not be applied until the select key is pressed, basically selecting that offset -Dumbed down the error message on the main screen so it only takes up one line, still need to go to fault menu to figure out what it means that it has not changed -Corrected MonstIR length data to what it should be. No support for 80M yet, also not 100% sure data is all correct v57 -Fixed scaling on 80m dipole, 16bit overflow v58 -Fixed frequency offset for both global and band v59 -Modified power on for remote driver with radio. -Changed antenna select so it would not clear options: remote, transciever, metric, poweroff v60 -Enabled status read on transciever when off -changed error message timing -fixed relays for home in create modify v61 -Made changes for new GH Radio remote driver link -Changed error message display -Fixed SmallIR coil scaling -Added power switch hold to force power off. v62 -Fixed metric mode on vertical with coil. v62 -Changed calibrate menu item to keep it from exiting too soon and creating an error message. v63 -Second attempt to keep calibrate from creating an error message.