Fluidmotion 6M adder Instructions
To use the 6M element the lengths for the first 6m segment (50.0
Mhz) must be changed. With firmware versions 6504 or later this is a simple
Firmware switch please see the Options menu in the Operator manual.
 Adding the 6M element makes a very good antenna between the frequencies 
of 50 to 50.5Mhz in the Normal Direction.
Unfortunately the 180 mode will not work with the passive element.
  
To do this:
     Mount the new 112 inch 6m element on the side of the antenna that 
     the elements are closest together (the same side of the mast as 
     the driven el is on). Mount it 31 inches from the Driven element, 
     measured from Center of the element tube to the Center of the Driven
     element tube.

If the Firmware is version 3B04 or earlyer the controller values will need 
to be changed.

     First select Ham mode.
     Select segment one of 6M (50.0Mhz) using the 6M band
     select button.
     Make sure the 180 and Bi-dir LEDs are Off (normal mode).
     Enter the Create Antenna mode in the setup menu.  Change
     the existing element lengths to the values shown below.
     Set DIR   = 104.3
     Set DVR   = adjust for the best SWR, some where around 108
     Set REF   = 116.8
     Select Done and Save and exit Setup menu back to Ham Mode.


      When using 6M select the first Normal Direction Segment in ham
     mode then adjust the frequency up to the desired frequency. It
     will also work using the transceiver interface in general coverage
     mode as long as you have the normal direction selected. To avoid
     possible confusion you may want to enter the same values for both
     the 180 and Bid modes so it will work no matter which mode you are
     in.


The antenna is centered on  the lower part of
     6M (50.0 MHz to 50.4 Mhz).  As you go higher in the band
     the gain and F/B starts to slowly drop off and the VSWR
     will climb to about 1.5:1.  Have fun on the Magic Band!