Fluidmotion 6M adder Instructions for the 4 Element To use the 6M element the lengths for the first 6m segment (50.0 Mhz) must be changed. With firmware versions 6504 or later this is a simple Firmware switch please see the Options menu in the Operator manual. Adding the 6M element makes a very good antenna between the frequencies of 50 to 50.5Mhz in the Normal Direction. Unfortunately the 180 mode will not work with the passive element. To do this: Mount the new 110.5 inch 6m element 43 inches from the Driven element tube, measured center to center, between the driven and the Mast plate. Mount the new 104.5 inch 6m element 69 inches from the Director two element tube, at the far end of the boom, measured center to center. If the Firmware is version 3B04 or earlyer the controller values will need to be changed. First select Ham mode. Select segment one of 6M (50.0Mhz) using the 6M band select button. Make sure the 180 and Bi-dir LEDs are Off (normal mode). Enter the Create Antenna mode in the setup menu. Change the existing element lengths to the values shown below. Set DIR1 = 104.6 - Use the 180 button to switch beteen dir1 and 2 Set DIR2 = 100.4 Set REF = 111.7 Set DVR = adjust for the best SWR, some where around 108 Select Done and Save and exit Setup menu back to Ham Mode. When using 6M select the first Normal Direction Segment in ham mode then adjust the frequency up to the desired frequency. It will also work using the transceiver interface in general coverage mode as long as you have the normal direction selected. To avoid possible confusion you may want to enter the same values for both the 180 and Bid modes so it will work no matter which mode you are in. The antenna is centered on the lower part of 6M (50.0 MHz to 50.4 Mhz). As you go higher in the band the gain and F/B starts to slowly drop off and the VSWR will climb to about 1.5:1. Have fun on the Magic Band! 4/21/05